libburn/libburn/spc.h

181 lines
6.1 KiB
C

/* -*- indent-tabs-mode: t; tab-width: 8; c-basic-offset: 8; -*- */
/* Copyright (c) 2004 - 2006 Derek Foreman, Ben Jansens
Copyright (c) 2006 - 2014 Thomas Schmitt <scdbackup@gmx.net>
Provided under GPL version 2 or later.
*/
#ifndef __SPC
#define __SPC
#include "libburn.h"
void spc_inquiry(struct burn_drive *);
void spc_prevent(struct burn_drive *);
void spc_allow(struct burn_drive *);
void spc_sense_caps(struct burn_drive *);
void spc_sense_error_params(struct burn_drive *);
void spc_select_error_params(struct burn_drive *,
const struct burn_read_opts *);
void spc_getcaps(struct burn_drive *d);
void spc_sense_write_params(struct burn_drive *);
void spc_select_write_params(struct burn_drive *,
struct burn_session *, int,
const struct burn_write_opts *);
#ifdef Libburn_enable_scsi_cmd_ABh
int spc_read_media_serial_number(struct burn_drive *d);
#endif
void spc_probe_write_modes(struct burn_drive *);
void spc_request_sense(struct burn_drive *d, struct buffer *buf);
int spc_block_type(enum burn_block_types b);
int spc_get_erase_progress(struct burn_drive *d);
/* ts A70315 : test_unit_ready with result parameters */
int spc_test_unit_ready_r(struct burn_drive *d, int *key, int *asc, int *ascq,
int *progress);
int spc_test_unit_ready(struct burn_drive *d);
/* ts A70315 */
/** Wait until the drive state becomes clear in or until max_sec elapsed */
int spc_wait_unit_attention(struct burn_drive *d, int max_sec, char *cmd_text,
int flag);
/* ts A61021 : the spc specific part of sg.c:enumerate_common()
*/
int spc_setup_drive(struct burn_drive *d);
/* ts A61021 : the general SCSI specific part of sg.c:enumerate_common()
@param flag Bitfield for control purposes
bit0= do not setup spc/sbc/mmc
*/
int burn_scsi_setup_drive(struct burn_drive *d, int bus_no, int host_no,
int channel_no, int target_no, int lun_no, int flag);
/* ts A61115 moved from sg-*.h */
enum response { RETRY, FAIL, GO_ON };
enum response scsi_error(struct burn_drive *, unsigned char *, int);
/* ts A61122 */
enum response scsi_error_msg(struct burn_drive *d, unsigned char *sense,
int senselen, char msg[161],
int *key, int *asc, int *ascq);
/* ts A61030 */
/* @param flag bit0=do report conditions which are considered not an error */
int scsi_notify_error(struct burn_drive *, struct command *c,
unsigned char *sense, int senselen, int flag);
/* ts A70519 */
int scsi_init_command(struct command *c, unsigned char *opcode, int oplen);
/* ts A91106 */
int scsi_show_cmd_text(struct command *c, void *fp, int flag);
/* ts B11110 */
/** Logs command (before execution). */
int scsi_log_command(unsigned char *opcode, int oplen, int data_dir,
unsigned char *data, int bytes,
void *fp_in, int flag);
/* ts B40731 */
/* Arbitrary SCSI log message */
int scsi_log_text(char *text, void *fp_in, int flag);
/* ts A91218 (former sg_log_cmd ts A70518) */
/** Legacy frontend to scsi_log_command() */
int scsi_log_cmd(struct command *c, void *fp, int flag);
/* ts B11110 */
/** Logs outcome of a sg command.
@param flag bit0 causes an error message
bit1 do not print duration
*/
int scsi_log_reply(unsigned char *opcode, int data_dir, unsigned char *data,
int dxfer_len, void *fp_in, unsigned char sense[18],
int sense_len, double duration, int flag);
/* ts A91221 (former sg_log_err ts A91108) */
/** Legacy frontend to scsi_log_reply().
@param flag bit0 causes an error message
bit1 do not print duration
*/
int scsi_log_err(struct burn_drive *d, struct command *c,
void *fp, unsigned char sense[18],
int sense_len, int flag);
/* ts B31112 */
int scsi_log_message(struct burn_drive *d, void *fp, char * msg, int flag);
/* ts B00728 */
int spc_decode_sense(unsigned char *sense, int senselen,
int *key, int *asc, int *ascq);
/* ts B00808 */
/** Evaluates outcome of a single SCSI command, eventually logs sense data,
and issues DEBUG error message in case the command is evaluated as done.
@param flag bit1 = do not print duration
@return 0 = not yet done , 1 = done , -1 = error
*/
int scsi_eval_cmd_outcome(struct burn_drive *d, struct command *c, void *fp_in,
unsigned char *sense, int sense_len,
time_t start_time, int timeout_ms,
int loop_count, int flag);
/* ts B40204 */
/* Verify by INQUIRY that the drive is indeed a MMC device.
*/
int spc_confirm_cd_drive(struct burn_drive *d, int flag);
/* The waiting time before eventually retrying a failed SCSI command.
Before each retry wait Libburn_scsi_retry_incR longer than with
the previous one. At most wait for Libburn_scsi_retry_umaX microseconds.
*/
#define Libburn_scsi_retry_usleeP 100000
#define Libburn_scsi_retry_incR 100000
#define Libburn_scsi_retry_umaX 500000
/* The retry waiting time for commands WRITE(10) and WRITE(12).
*/
#define Libburn_scsi_write_retry_usleeP 0
#define Libburn_scsi_write_retry_incR 2000
#define Libburn_scsi_write_retry_umaX 25000
/* ts B11124 */
/* Millisecond timeout for quickly responding SPC, SBC, and MMC commands */
#define Libburn_scsi_default_timeouT 30000
/* WRITE(10) and WRITE(12) */
#define Libburn_scsi_write_timeouT 200000
/* RESERVE TRACK */
#define Libburn_mmc_reserve_timeouT 200000
/* CLOSE TRACK/SESSION with Immed bit */
#define Libburn_mmc_close_timeouT 200000
/* CLOSE TRACK/SESSION without Immed bit */
#define Libburn_mmc_close_noim_timeouT 3600000
/* BLANK , FORMAT UNIT with Immed bit */
#define Libburn_mmc_blank_timeouT 200000
/* BLANK , FORMAT UNIT without Immed bit */
#define Libburn_mmc_blank_noim_timeouT 18000000
/* SEND OPC INFORMATION */
#define Libburn_mmc_opc_timeouT 200000
/* MMC_SYNC_CACHE with Immed bit */
#define Libburn_mmc_sync_timeouT 200000
/* MMC_SYNC_CACHE without Immed bit */
#define Libburn_mmc_sync_noim_timeouT 3600000
/* START STOP UNIT with Start bit and Load bit set */
#define Libburn_mmc_load_timeouT 300000
#endif /*__SPC*/